Lenovo ThinkStation P910, Руководство по техническому обслуживанию аппаратной части

Страница: 191 / 244

7. Pivot the handle 2 to the right until it stops, and then press it downward until the latch 1 snaps into
position. Pivot the tab 3 inward until it snaps into position.
2
3
1
Figure 142. Closing PCI card latches
8. Connect the power cable of the full-length PCI Express card to the new card. See “Parts on the
system board” on page 35.
9. Reinstall the direct cooling air baffle if you have removed it. See “Direct cooling air baffle” on page 105.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 213.
Super capacitor module
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 “Read this first: Important safety information” on page 1.
To install or replace the super capacitor module, do the following:
1. Prepare your computer. See “Preparing your computer and removing the computer cover” on page 101.
2. Lay the computer on its side for easier access to the super capacitor module.
3. Locate the PCI Express card slot in which the super capacitor module holder is installed. See “Computer
components” on page 32.
Chapter 9
.
Installing or replacing hardware
185