Lenovo ThinkStation P910, Руководство по техническому обслуживанию аппаратной части

Страница: 114 / 244

• Optical drive
• Flex module
Note: The flex module might be installed with the following:
– IEEE 1394 connector
– eSATA connector
– 29-in-1 card reader
– Slim optical drive
– Front Thunderbolt adapter kit
• Fex bay storage enclosure
• Front-access storage enclosure
• Multi-drive conversion kit
• Slim-optical-drive adapter
To remove and install a flex module or a flex bay storage enclosure, follow the steps of removing and
installing an optical drive.
To remove an optical drive, do the following:
1. Prepare your computer. See “Preparing your computer and removing the computer cover” on page 101.
2. Remove the direct cooling air baffle. See “Direct cooling air baffle” on page 105.
3. Locate the optical-drive bay from which you want to remove an optical drive. See “Internal drives”
on page 37.
4. Disconnect the cables from the optical drive.
Note: If you remove a flex module or a flex bay storage enclosure, you might need to disconnect the
cables from the device, a PCI card, or the system board. See “Parts on the system board” on page 35.
5. Press the tab 1 downward and push the optical drive to the front of the chassis. Then, remove the
optical drive from the front of the chassis.
1
Figure 17. Removing the optical drive
To install an optical drive, do the following:
1. Prepare your computer. See “Preparing your computer and removing the computer cover” on page 101.
2. Remove the direct cooling air baffle. See “Direct cooling air baffle” on page 105.
3. Locate the optical-drive bay into which you want to install an optical drive. See “Internal drives” on
page 37.
108
P910 Hardware Maintenance Manual