Lenovo ThinkServer TD330, Руководство пользователя

Страница: 151 / 218

10. Align the top edge of the EMI-protective panel with the top side of the hard disk drive cage, and then
pivot the EMI-protective panel down until it snaps into position.
Figure 75. Installing the EMI-protective panel
11. Disconnect the SATA cable for the removed non-hot-swap hard disk drive from the system board and
save the cable for future use.
12. Close and lock the front door.
13. If you are instructed to return the old non-hot-swap hard disk drive, follow all packaging instructions and
use any packaging materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the removal procedure, go to “Completing the parts replacement” on page 178. Then, you
might need to reconfigure RAID for your server. See “Configuring RAID” on page 64.
Installing or replacing the microprocessor
This topic provides instructions on how to install or replace the microprocessor.
Installing the second microprocessor
Attention: Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii and “Guidelines” on page 75.
This topic provides instructions on how to install the second microprocessor.
Depending on the model, your server might come with one or two microprocessors. For server models with
one microprocessor, the microprocessor is installed in the microprocessor socket 1 and the microprocessor
Chapter 6
.
Installing, removing, or replacing hardware
137