Lenovo System x3250 M4, Инструкция по установке и обслуживанию

Страница: 88 / 614

Step 4. On the next screen, select Integrated Management Module .
Step 5. On the next screen, select Network Configuration .
Step 6. Find the IP address and write it down.
Step 7. Exit from the Setup utility.
Logging on to the web interface
Use this information to log on to the web interface.
To log on to the IMM web interface, complete the following steps:
Step 1. On a system that is connected to the server, open a web browser. In the Address or URL field,
type the IP address or host name of the IMM to which you want to connect.
Note: If you are logging on to the IMM for the first time after installation, the IMM defaults to
DHCP. If a DHCP host is not available, the IMM assigns a static IP address of 192.168.70.125.
The IMM network access tag provides the default host name of the IMM and does not require
you to start the server.
Step 2. On the Login page, type the user name and password. If you are using the IMM for the first time,
you can obtain the user name and password from your system administrator. All login attempts are
documented in the system-event log.
Note: The IMM is set initially with a user name of USERID and password of PASSW0RD (with a
zero, not a the letter O). You have read/write access. You must change the default password the
first time you log on.
Step 3. Click Log in to start the session. The System Status and Health page provides a quick view
of the system status.
Note: If you boot to the operating system while in the IMM GUI and the message “Booting OS or in
unsupported OS” is displayed under System Status ➙ System State , disable Windows 2008 or 2012
firewall or type the following command in the Windows 2008 or 2012 console. This might also affect
blue-screen capture features.
netsh firewall set icmpsetting type=8 mode=ENABLE
By default, the icmp packet is blocked by Windows firewall. The IMM GUI will then change to “OS booted”
status after you change the setting as indicated above in both the Web and CLI interfaces.
Using the embedded hypervisor
The VMware ESXi embedded hypervisor software is available on the optional IBM USB flash device with
embedded hypervisor.
The USB flash device can be installed in USB connectors on the system board (see “System-board internal
connectors” on page 21 for the location of the connectors). Hypervisor is virtualization software that enables
multiple operating systems to run on a host system at the same time. The USB flash device is required to
activate the hypervisor functions.
To start using the embedded hypervisor functions, you must add the USB flash device to the startup
sequence in the Setup utility.
To add the USB flash device to the startup sequence, complete the following steps:
Step 1. Turn on the server.
74
Lenovo System x3250 M4 Installation and Service Guide