Lenovo RackSwitch G8264, Справочник по командам

Страница: 651 / 794

© Copyright Lenovo 2017 Chapter 4: Configuration Commands
651
network private ­ vlan {host|trunk|promiscuous}
Configures the virtual port’s Private VLAN mode:

host
allows only ONE secondary VLAN. In case of network trunk mode,
the other VLANs will be in non ‐ Private VLANs. A virtual port operating in
Private VLAN host mode cannot belong to multiple Private VLAN
domains.

trunk
allows both primary and secondary VLAN as well as non ‐ Private
VLAN domains. The Isolate ‐ VLAN is also allowed to pass through this port
type.

promiscuous
allows private VLAN promiscuous mode
Note: Virtual ports that are part of the same physical port cannot belong to the
same Private VLAN domain.
Command mode: UFP Virtual Port Configuration
no network private ­ vlan
Disables private ‐ VLAN mode on the virtual port.
Command mode: UFP Virtual Port Configuration
qos bandwidth {max
<10 ‐ 100>
|min
<10 ‐ 100>
}
Configures bandwidth allocation for the virtual port:

Configures the minimum bandwidth guaranteed for the virtual port as a
percentage of the physical port’s bandwidth. The default value is
25
.

Configures the maximum bandwidth allowed for this virtual port as a
percentage of the physical port’s bandwidth. The default value is
100
.
Note : The aggregated minimum bandwidth guaranteed for all the virtual
ports within a physical port cannot exceed 100.
Command mode: UFP Virtual Port Configuration
qos ets priority
<802.1q priority(0 ‐ 7)>
Configures the 802.1q priority of the traffic going through the virtual port.
The default value is
0
.
Command mode : UFP Virtual Port Configuration
[no] qos ets host ­ control
Enables or disables the switch to automatically configure the 802.1p priority of
the traffic traversing the virtual port.
The default value is
disabled
.
Command mode : UFP Virtual Port Configuration
Table 371.
UFP Commands (continued)
Command Syntax and Usage