Lenovo RackSwitch G8264, Справочник по командам

Страница: 637 / 794

© Copyright Lenovo 2017 Chapter 4: Configuration Commands
637
VMReady Configuration
The following table describes the VMReady configuration options.
VM Policy Bandwidth Management
The following table describes the bandwidth management options for the selected
VM. Use these commands to limit the bandwidth used by each VM.
Table 361.
VMReady Configuration Options
Command Syntax and Usage
[no] virt enable
Enables or disables VMReady. Before you enable VMReady, you must define
one or more server ports. See “Server Port Configuration” on page 399 .
Note : The
no
form of this command deletes all configured VM groups.
Command mode : Global configuration
show virt
Displays the current virtualization parameters.
Command mode : All
Table 362.
VM Bandwidth Management Options
Command Syntax and Usage
[no] virt vmpolicy vmbwidth {
<MAC address>
|
<UUID>
|
<name>
|
|
<IP address>
|
<index number>
} bwctrl
Enables or disables bandwidth control on the VM policy.
Command mode: Global configuration
virt vmpolicy vmbwidth {
<MAC address>
|
<UUID>
|
<name>
|
|
<IP address>
|
<index number>
} rxrate
<0 ‐ 40000000> <max. burst (0 ‐ 4096)>
The first value configures Committed Rate—the amount of bandwidth
available to traffic transmitted from the switch to the VM, in kilobits per
second. Enter the value in multiples of 64.
The second values configures the maximum burst size, in kilobits. Enter one of
the following values:
0
,
32
,
64
,
128
,
256
,
512
,
1024
,
2048
or
4096
.
Command mode: Global configuration