Lenovo RackSwitch G8264, Справочник по командам

Страница: 605 / 794

© Copyright Lenovo 2017 Chapter 4: Configuration Commands
605
virtual ­ router
<1 ‐ 128>
timers preempt ­ delay ­ time
<0 ‐ 255>
Configures the preempt delay interval (in seconds). This timer is configured
on the virtual router and prevents the switch from transitioning back to Master
state until the preempt delay interval has expired. Ensure that the interval is
long enough for OSPF or other routing protocols to converge.
The default is
0
seconds.
Command mode: Router VRRP
virtual ­ router
<1 ‐ 128>
track
Enables the priority system used when electing the master router from a pool
of virtual routers. To view command options, see page 606 .
Command mode: Router VRRP
virtual ­ router
<1 ‐ 128>
virtual ­ router ­ id
<1 ‐ 128>
Defines the virtual router ID (VRID). This is used in conjunction with the
[no] virtual ­ router
<VRID>
address
<IP address> command below to
define a virtual router on this switch. To create a pool of VRRP ‐ enabled
routing devices which can provide redundancy to each other, each
participating VRRP device must be configured with the same virtual router.
The VRID for standard virtual routers (where the virtual router IP address is
not the same as any virtual server) can be any integer between 1 and 128.
The default value is
1
.
Note: All VRID values must be unique within the VLAN to which the virtual
router’s IP interface belongs.
Command mode: Router VRRP
no virtual ­ router
<1 ‐ 128>
Deletes this virtual router from the switch configuration.
Command mode: Router VRRP
show ip vrrp virtual ­ router
<1 ‐ 128>
Displays the current configuration information for this virtual router.
Command mode: All
Table 332.
VRRP Virtual Router Configuration Options (continued)
Command Syntax and Usage