Lenovo 6241, Инструкция по установке и обслуживанию

Страница: 150 / 1990

Step 2. On the Login page, type the user name and password. If you are using the IMM for the first time,
you can obtain the user name and password from your system administrator. All login attempts are
documented in the system-event log.
Note: The IMM is set initially with a user name of USERID and password of PASSW0RD (with a
zero, not a the letter O). You have read/write access. You must change the default password the
first time you log on.
Step 3. Click Log in to start the session. The System Status and Health page provides a quick view of the
system status.
Note: If you boot to the operating system while in the IMM GUI and the message “Booting OS or in
unsupported OS” is displayed under System Status
→
System State , disable Windows 2008 firewall or type
the following command in the Windows 2008 console. This might also affect blue-screen capture features.
netsh firewall set icmpsetting type=8 mode=ENABLE
By default, the icmp packet is blocked by Windows firewall. The IMM GUI will then change to “OS booted”
status after you change the setting as indicated above in both the Web and CLI interfaces.
Logging on to the IMM CLI interface using telnet
This topic provides instructions on how to log on to the IMM CLI interface using telnet.
To log on to the IMM CLI interface using telnet, complete the following steps:
Note: If you boot to the operating system while in the IMM GUI and the message “Booting OS or in
unsupported OS” is displayed under System Status → System State , disable Windows 2008 firewall or type
the following command in the Windows 2008 console. This might also affect blue-screen capture features.
netsh firewall set icmpsetting type-8 mode=ENABLE
By default, the icmp packet is blocked by Windows firewall. The IMM GUI will then change to “OS booted”
status after you change the setting as indicated above in both the Web and CLI interfaces.
Step 1. From the command prompt, type telnet ; then, the IP address for the IMM to which you want to log
on to and press Enter .
Step 2. Type the USERID and PASSWORD for the IMM and press Enter .
Step 3. At the system prompt, type your command.
Note: You can type help in the command prompt if you want to see a list of commands that you
can use.
Step 4. When you are finished, type Exit , to exit the session.
Logging on to the IMM CLI interface using SSH
This topic provides instructions on how to log on to the IMM CLI interface using SSH.
To log on to the IMM CLI interface using SSH, complete the following steps:
Note: If you boot to the operating system while in the IMM GUI and the message “Booting OS or in
unsupported OS” is displayed under System Status → System State , disable Windows 2008 firewall or type
the following command in the Windows 2008 console. This might also affect blue-screen capture features.
netsh firewall set icmpsetting type-8 mode=ENABLE
By default, the icmp packet is blocked by Windows firewall. The IMM GUI will then change to “OS booted”
status after you change the setting as indicated above in both the Web and CLI interfaces.
Step 1. From the command prompt, type ssh , then press Enter .
Step 2. Type USERID@IPADDRESS in the command prompt (where the USERID and IP ADDRESS is the
user ID and IP address for the IMM to which you want to log on to), then press Enter .
136
System x3850 X6 and x3950 X6 Installation and Service Guide