7: Network and Modem Settings
SLM User Guide
66
2. Enter the following:
Table 7-8 Network Gateway
3. To save your entries, click the
Update
button.
Keep Alive
Keep Alive settings keep TCP connections active and monitor for connections that are no longer
active.
To enter Keep Alive settings:
1. Click the
Keep Alive
tab.
2. Enter the following information:
Table 7-9 Keep Alive Settings
Network Gateway
Setting
Description
Default
IP address of the router for this network.
If this has not been set manually, any gateway assigned by DHCP for Network Port
1 or Network Port 2 displays.
All network traffic that matches the Network Port 1 0IP address and subnet mask
goes out Network Port 1. All network traffic that matches the Network Port 2 IP
address and subnet mask goes out Network Port 2.
If you set a default gateway, the SLM sends any network traffic that does not match
Network Port 1 or Network Port 2 to the default gateway for routing.
DHCP Acquired
(view only)
Gateway assigned by DHCP for Network Port 1 or Network Port 2. The default
setting is
None
.
Precedence
Indicates whether the gateway assigned by DHCP or the default gateway takes
precedence. The default setting is Default. If you select DHCP, and both network
ports are configured for DHCP, the SLM gives precedence to the Network Port 1
gateway.
Alternate
An alternate IP address of the router for this network, to be used if an IP address
usually accessible through the default gateway fails to return one or more pings.
IP Address to Ping
IP address to ping to determine whether to use the alternate gateway.
Ethernet Port to
Ping
Ethernet port to use for the ping.
Delay between
Pings
Number of seconds between pings
Number of Failed
Pings
Number of pings that fail before the SLM uses the alternate gateway.
Keep Alive Setting
Description
Start Probes
Number of seconds the SLM waits after the last transmission before sending the
first probe to determine whether a TCP session is still alive. The default is 600
seconds (10 minutes).
Number of Probes
Number of probes the SLM sends before closing a session. The default is 5.
Interval
The number of seconds the SLM waits between probes. The default is 60 seconds.
Содержание SLM
