Landoll Brillion SS16, Руководство оператора

Страница: 81 / 100

4-3
TABLE OF CONTENTS
Speed Source Displays
Figure 4-3: Source: Shaft Sensor Speed Display
Figure 4-4: Source: Radar Speed Display
Figure 4-5: Source: GPS Receiver Display
Figure 4-6: Source: Simulated Speed Display
Speed Source Icon Features
Pulses Per Revolution
Pulses Per Revolution are the
number of magnets the implement
mounted speed sensor sees in one
revolution of the shaft being monitored. For Brillion
Seeders this number is 4.
To change, enter a new number into the keypad and
select
“Exit & Save” .
Wheel Pulses Per 400FT
This is the ground speed calibration
number for a implement mounted
speed sensor. See
"Speed
Calibration" for calibration instructions.
The Default number is 90. MUST BE CHANGED to 358.
To change, enter a new number into the keypad and
select
“Exit & Save” . Increasing this number will cause
the monitor to show a slower MPH, decreasing it causes
the MPH to increase.
Radar Pulses Per 400FT
This is the ground speed calibration
number for a radar speed sensor.
See
"Speed Calibration" for
calibration instructions.
Speed (Simulated Speed)
Enter the static speed of your
choice. The monitor will continually
display this speed at all times until
otherwise specified.
IMP. SWITCH:
DISABLED
SOURCE:
SHAFT SPEED
SPEED SETTINGS
WHEEL
90
SWITCH
SETTING PULSES PER
4
BACK
SPEED
CALIBRATION
IMP. SWITCH:
DISABLED
SOURCE:
RADAR
SPEED SETTINGS
SWITCH
SETTING RADAR PULSES
15815
BACK
SPEED
CALIBRATION
IMP. SWITCH:
DISABLED
SOURCE:
GPS
SPEED SETTINGS
SWITCH
SETTING
BACK
IMP. SWITCH:
DISABLED
SOURCE:
SIM. SPEED
SPEED SETTINGS
SWITCH
SETTING SPEED:
5.0 MPH
BACK
PULSES PER
REV:
4
WHEEL PULSES
PER 400FT:
90
RADAR PULSES
PER 400FT:
15815
SPEED:
5.0 MPH