Landoll Brillion SS16, Руководство оператора

Страница: 63 / 100

F-1021-0422 3-5
TABLE OF CONTENTS
Tractor Preparation/Attaching of
Pull Type Seeder
DANGER
DANGER
1. The Seeder is designed to be used with a Category 2
or 3 Drawbar Hitch.
2. Align the Tractor Drawbar with the machine. Raise or
lower the Drawbar Hitch as needed using the Jack.
Attach the unit with proper size Hitch Pin and Safety
Clip.
See Table 3-1.
Table 3-1: Pin Size
3. Raise and rotate Jack to stored position before setting
the machine in motion.
4. Clean all hydraulic couplings and attach to the tractor.
5. Attach safety chain to tractor allowing plenty of
movement for turning both directions. The safety
chain should latch securely to prevent it coming loose.
See “Safety Chain” on page 1-4.
6. If Transport Locks are not engaged, fully extend the
hydraulic lift cylinders and rotate Transport Locks in
the engaged position over the Cylinder Rods. Secure
with the Clevis Pins and Hairpin Cotters.
See
Figure 3-5.
Figure 3-5: Transport Lock Engaged
7. Connect the 7-Pin Connector to Tractor Outlet,
routing cable by avoiding pinch points.
• Make sure the tractor has a good clean
receptacle, free of dirt and corrosion.
• Make sure the 7-Pin Connector is inserted ALL the
way in. With tighter fitting pins, operator may think
the Connector is all the way in, but really isn’t.
• Make sure the tractor receptacle cover latches
over the keyway on the 7-Pin Connector to hold
the Connector in place.
• If an operator plugs in the 7-Pin Connector, but
the lights do not seem to work right, check the
above items to make sure there is a good
connection with the 7-Pin Connector.
8. Install Clutch and any other Optional Harnesses to
tractor if applicable.
9. If equipped with a Clutch, install Basic Clutch Switch
or Brillion Elite Mini Monitor to tractor. Connect the
3-Pin Plug to the 12 Volt Tractor Convenience Outlet.
Basic Clutch Switch: Connect 2-Pin Connector to
Cable Assembly.
Brillion Elite Mini Monitor: Connect 6-Pin
Connector to 240" Extension Harness
Do not allow any bystanders to stand between the
tractor and the implement while backing up to the
implement.
DRAWBAR CAT Min Pin Size Max PTO HP
2 1-1/4" (30mm) 154 (115 Kw)
3 1-1/2" (38mm) 248 (185 Kw)
Clevis Pin,
1/2 x 4
Hair Pin
Cotter
Transport
Lock
Hyd Cyl