Landoll Brillion SS16, Руководство оператора

Страница: 82 / 100

4-4 F-1021-0422
TABLE OF CONTENTS
Speed Calibration
All new systems require a ground
speed calibration to ensure
accurate area totals and accurate
ground speed readings. To complete the calibration,
measure a course 400 long preferably on level ground
with a start and finish point. The seeder must be in the
down position throughout this procedure.
NOTE
During the calibration the monitor is looking for the
number of pulses produced from the seeder mounted
sensor or in the case of radar, the number of radar pulses.
1. Select the “Start Calibration”
button to begin.
2. As you drive the 400ft.
distance, pulses for both Wheel Pulses and/or Radar
Pulses will begin accumulating on-screen.
3. When you’ve reached the end of the 400ft. distance,
select “EXIT & SAVE” to complete the calibration
procedure. Depending on which “Speed Source” is
selected, the monitor will store this value into either
the
“Wheel Pulses Per 400” or “Radar Pulses Per
400” area.
Implement Switch
The implement switch is used to tell
the monitor if a Lift Sensor is being
used to determine when the
machine is raised or lowered. The Lift Sensor is used
when shaft rotation cannot be used or a variable rate drive
such as common on air seeders, is being used. The
“Imp.
Switch” button toggles between “Disabled” or
“Enabled” . Set to “Disabled” for Brillion SS16 Seeder .
When the Monitor learns a
“Lift Switch Sensor” toggle the
“Implement Switch” button to
“Enabled” .
Implement Switch Setup
Implement Switch
Setup tells the
monitor if the
Implement Switch
Lift Sensor is
associated with the
Implement Lift
being raised or
lowered.
The Implement
Switch Setup toggles between
“Open” or “Closed” .
Select icon “Set Highest” or “Set Lowest” to “Open”
the Implement Switch, the other will automatically
“Close” .
Settings Menu -
Clutch Setting
The SS16 Seeder has a Clutch that is controlled by the
Brillion Elite Mini Monitor. The Clutch must be set.
1. Set “Total Clutches” to 1 by pressing icon “-” or “+”
2. Set each “Clutch Details” as follows: to toggle
between each Clutch Detail press icon NEXT or
PREV.
• Clutch engage at: 12 Volts
(Toggles between 0 and 12 Volts)
• Section Width: 16.0 Feet
3. Select “BACK” to get to the Setting Menu.
SPEED
CALIBRATION
SPEED CALIBRATION
1. Measure 400ft distance
2. Select “START CALIBRATION”
and begin driving.
3. Pulses will start accumulating below.
4. Select “EXIT AND SAVE” below to complete.
START
WHEEL PULSES RECEIVED :
0
RADAR PULSES RECEIVED :
0
BACK EXIT & SAVE
SPEED
CALIBRATION
SPEED
CALIBRATION
IMP. SWITCH:
DISABLED
IMP. SWITCH:
ENABLED
IMP. SWITCH SETUP
BACK
SET HIGHEST
SET LOWEST
RAISED:
OPEN
CURRENT:
OPEN
LOWERED:
CLOSED
SWITCH
SETTINGS
CLUTCH
SETTINGS
CLUTCH SETTINGS
BACK
PREV. NEXT
CLUTCH
ENGAGE
AT:
12V
SECTION
WIDTH:
16.0 FT
TOTAL
CLUTCHES
1
CLUTCH 1 DETAILS: