Land Pride RCM3615, Руководство оператора

Страница: 42 / 64

Section 4: Options & Accessories
RC3615 and RCM3615 Series 2 S/N Rotary Cutters 330-502M 12/12/18
38
Table of Contents
Mechanical Wing Lift
330-295A Mechanical Winch
Refer to Figure 4-1:
An optional manual wing lift kit is available for raising the
wing to transport position when the hydraulic system is
not working or when the towing vehicle is not equipped
with the proper hydraulic connections.
Pull hook (#5) with cable out. Attach cable to wing deck
by routing the cable around the cylinder pin between the
clevis brackets and clipping the hook back to the cable.
The cylinder rod end will need to be disconnected from
the wing if the rod will not retract.
Wing Lift Installation Instructions
Attach mechanical winch mounting frame (#1) to the
center deck in the location shown with 5/8"-11 x 2" GR5
cap screws (#2), flat washers (#4), and hex flange
locknuts (#3). Tighten nuts to the correct torque.
Mechanical Winch Assembly
Figure 4-1
Cylinder Pin
27951
Mechanical Wing Lift Operation
DANGER
!
To avoid serious injury or death:
• Make sure no one is in the area where the deck will be
raised. The cable could come loose or break and drop the
wing suddenly causing serious bodily injury or death.
•
If a cylinder fitting was loosened to mechanically raise the
wing deck up, be sure to also lower the wing deck with the
mechanical winch. Do not use the cylinder to lower the
deck. It will have an excess amount of air and will drop the
deck suddenly.
1. Pull cable hook with cable out past the gearbox.
2. Attach cable to wing deck by routing cable around the
wing gearbox base and clipping the hook back to the
cable or by hooking the cable to the wing deck side
panel. Make certain the cable is secured and will not
slip or come loose before raising the deck up.
3. Turn mechanical winch handle to raise deck. If
cylinder rod will not retract while raising the wing up,
loosen hydraulic fitting on the rod side of the cylinder
to allow intake of air while raising the wing.
4. Secure wing deck in the raised position with cylinder
transport lock. See “Transport Locks” instructions
on page 34.
5. Tighten hydraulic fitting if loosened.
6. Lower wing deck as follows:
If hydraulic fitting was not loosened:
a. Unhook cable and reel cable up.
b. Connect hydraulic hose to a tractor and lower
wing deck with tractor control lever.
If hydraulic fitting was loosened:
a. Loosen hydraulic fitting at the cylinder to allow
intake air to escape while lowering the wing deck.
b. Remove transport lock and lower wing deck with
mechanical winch.
c. Tighten hydraulic fitting and connect all hydraulic
hoses to a tractor.
d. Purge hydraulic system of air. See “Purge
Hydraulic System” on page 23.
IMPORTANT: If wing driveline profile is bent or
twisted, disconnect that driveline from the wing
gearbox before folding the wing up. This will protect
both the wing and divider gearbox. Repair driveline
before putting cutter back into service.