18
Section 3: Mower Deck
ZSR54 & ZSR60 Accu-Z Razor
®
Zero Turn Mowers 357-388SM
7/30/12
Table of Contents
Figure 3-4
Figure 3-5
Figure 3-6
33713
33714
33715
Deck installation
Refer to Figure 3-4:
1.
Slide the deck assembly under the mower and align
the deck so that the lift chains are under each of the
deck lift arms.
2.
Raise the deck approximately 3 to 4 inches to allow
slack in the deck lift chains when installing.
3.
Install the deck lift arm chain bolts on the deck chains
and secure with the inner flange nuts.
4.
Attach the deck lift chains to the deck lift arms and
secure with the flanged nuts.
Refer to Figure 3-5:
5.
If the deck interface arms were removed during deck
removal, align and reinstall the deck interface arms
to the frame with pivot bolts and flanged lock nuts. Do
not tighten until the deck interface gimbals have been
secured to the deck strut bracket.
6.
Align the deck interface arm gimbals to the inside of
the deck strut bracket. Secure with bolts and
locknuts through the interface gimbals. Tighten strut
pivot bolt lock nuts.
Refer to Figure 3-6:
7.
Install belt on the clutch insuring correct belt routing
as per the “Deck Drive Belt Removal &
Installation” on page 64.
8.
Tighten belt by rotating the over center latch
assembly clockwise until the latch assembly
engages. Secure the over center latch with the latch
pin.
9.
Remove blocks and adjust deck as per the “Deck
Adjustments” on page 50.
NOTE: Do not over tighten the chain on the bolt.
The chain should pivot easily on the bolt.
