17
Section 3: Mower Deck
7/30/12
ZSR54 & ZSR60 Accu-Z Razor
®
Zero Turn Mowers 357-388SM
Table of Contents
Figure 3-1
Figure 3-2
Figure 3-3
33711
33712
33690
Deck Removal
Refer to Figure 3-1:
1.
Chock wheels to secure mower and prevent
movement while repairs are made.
2.
Remove the deck height stop from the height gauge
bar.
3.
Place blocks or pallet skid under the mower deck and
lower the deck until the deck is fully supported and
the deck chains are slack.
4.
Raise floor panel to access the over center latch.
Loosen deck belt tension by pulling the securing pin
on the over center latch assembly and rotate counter
clockwise to disengage the latch. Remove belt from
the clutch.
Refer to Figure 3-2:
5.
Remove the seat pan assembly from the mower for
ease of access. See “Seat and Latch Removal” on
page 13.
6.
Loosen the nuts on the bolts for the deck interface
gimbals and remove the bolts from the deck strut
bracket.
7.
The deck interface arms may be removed or secured
to prevent them from falling onto the deck during
removal of the deck.
Refer to Figure 3-3:
8.
Loosen and remove the flanged nuts securing the
deck lift chains to the deck lift arms. Remove the
bolts from the deck lift chains and allow the chains to
drop down onto the mower deck.
9.
Remove the deck assembly from under the mower by
pulling it out from the side.
NOTE: Lift chains do not need to be removed from
the deck for these repairs.
Section 3: Mower Deck
