6
Section 1: Operator Controls
ZSR54 & ZSR60 Accu-Z Razor
®
Zero Turn Mowers 357-388SM
7/30/12
Table of Contents
Figure 1-7
Figure 1-8
Figure 1-9
33684
33683
33682
Control Arm and Lever Installation
Refer to Figure 1-7:
1.
Install flanged wear pivot bushings in both sides of
the control arm.
Refer to Figure 1-8:
2.
Align and install the steering lever on the control arm
bolt.
3.
Install the pivot washer, compression spring,
retaining washer and retaining lock nut.
4.
Tighten compression spring lock nut until threads are
showing, may be adjusted to desired tension after
installation onto frame.
5.
Install the damper stud into the rod end of the
damper and secure with retaining cap.
6.
Insert threaded end of damper stud into the control
arm. The control rod retaining nut may be loosely
installed to aid in assembly.
Refer to Figure 1-9:
7.
Push the control lever out into the brake position and
insert though frame.
8.
Align and install the control arm on the frame
mounting bolt, secure with retaining washer and lock
nut.
9.
Tighten the steering arm retaining lock nut until tight,
then back off 1/8th of a turn to allow for free
movement of the steering arm.
10. Align and install the drive control rod assembly on
the threaded end of the control arm damper stud,
and secure with retaining lock nut.
11. Align and install base end of damper on frame stud
and secure with locking cap.
12. Install steering arm. See “Steering Arm
Installation” on page 4.
13. Repeat steps 1 though 12 for other side.
NOTE: Ensure correct alignment for left or right
hand side when inserting damper stud so that the
damper will be between frame and control arm.
