8
A. Water Type
D. Ice/No Ice Ratio
B. Brand Library Tabs
E. Input Ratio
C. Replacement Brand
A
E
D
B
C
9. Select a new brand from the available Brands Library tabs
on the left side of the screen.
10.
Once a brand/flavor has been selected to a corresponding
module, press the Configuration button to return to the
Configuration Screen.
11.
Repeat steps 8 and 9 for any other desired brand or flavor
modules.
12. Press the Menu button to return to the Service menu.
13. From the Service Menu, press the Maintenance button.
14. Press the Purge tab on the far left side of the screen.
15.
Purge any new brand or flavor module until there is a steady
flow of product. (See page 6)
16. Press the Menu button to return to the Service Menu.
CALIBRATION AND MAINTENANCE
Calibrating Carbonated/Plain Water Modules
1. From the Service menu, press the Maintenance button.
2. Press the Calibrate tab on the far left side of the screen and
press the Calibrate button for the carbonated water module.
3.
Enter the desired flow rate in milliliters per second (ml/sec).
This number is based on the target finished drink flow rate of
44 ml/sec and the desired drink ratio.
Finished drink flow rate = 44 ml/sec
Ratio = 5.4:1
44 ml/s X 5.4 / (5.4 + 1) = 37.13 ml/sec water flow rate
44 ml/s X 1 / (5.4 + 1) = 6.87 ml/sec syrup flow rate
EXAMPLE
4.
Set the Timer to the ON position and select milliliters (ml) as
the desired unit of measurement.
5.
Using the keypad, enter a specific volume to be dispensed
based on the size of the graduated cylinder being used
to calibrate the carbonated water module. The larger the
volume dispensed, the more accurate the results. Use the
example
150 ml
.
A. Enter Flow Rate C. Start Purge Button
B. Timer Icon
D. Unit Icon
A
B
C
D
Each brand has a default water type and ratio already
set when they are selected. The water type and ratio
can be adjusted if necessary, adjust the ratio by
selecting the “Ice” or “No Ice” ratio using the buttons
in the upper right corner of the screen, or by tapping
the number and entering the new value on the keypad.
However adjusting the ratio here is purely represen-
tational. Each valve must still be manually adjusted in
order for the ratio to be set, (see next section).
NOTE
