Lagler Superhummel, Эксплуатация Обслуживание Безопасность

Страница: 59 / 102

SUPERHUMMEL
01.11.2011
ENGLISH
4
COMMISSIONING
Fig. 16 Release the switch button. The button turns
automatically in position -1-.
Fig. 17 The motor do not start (1.) and the light on the
switch box shines (2.).
Fig. 18 Change the rotation direction of the motor.
If the motor do not start (Fig. 17, 1.) and the light on the switch box
shines (Fig. 17, 2.), the rotation direction of the motor is wrong.
To change the rotation direction of the motor using the follow-
ing procedure:
1 Disconnect the motor cable from extension cable.
2 Put a screw driver in the slit of the phase changing switch
at the motor cable (Fig. 18, 1.).
3 Turn the screw driver 180° (Fig. 18, 2.).
4.3.2 MACHINES WITH SINGLE-PHASE AC MOTOR
(MAINS VOLTAGE 230 V AND 220 V)
1 Lift the sanding drum off the floor by turning the lowering
lever at the handle upwards (Fig. 12).
2 To switch on the motor turn the switch button to position
-START- and hold the switch button for around 2 seconds
in this position (Fig. 19).
3 Once the motor has reached its full speed, release the
switch button. The switch button will then automatically
move to position -BETRIEB (WORKING)- (Fig. 20).
ATTENTION!
Remaining for too long in the switch position -START-
shortens the service life of the starting capacitor!
Fig. 19 To switch on the motor turn the switch button to
position -START- and hold the switch button for
around 2 seconds in this position.
Similar to figure.
Fig. 20 Once the motor has reached its full speed, re-
lease the switch button. The switch button will
then automatically move to position -BETRIEB
(WORKING)-.
Similar to figure.
59