Lagler Superhummel, Эксплуатация Обслуживание Безопасность

Страница: 55 / 102

SUPERHUMMEL
01.11.2011
ENGLISH
This section describes the procedure for commissioning the
SUPERHUMMEL on site. In order to exclude the possibility of
damage and malfunctions, it is essential to proceed in the se-
quence outlined below.
ATTENTION!
Before working with the machine for the first time, operating
staff must be adequately instructed!
4.1 PREPARING THE MACHINE
1 Unpack the machine cautiously. Pay attention to a non-
polluting disposal of the packing materials.
2 Insert the guide tube into the opening at the back of the
machine housing (Fig. 2, 1.) and tighten the wing nut (Fig.
2, 2.).
3 Put the lower rod in the hole of the lifting fixture (Fig. 3, 1.)
and fix them with the closure (Fig. 3, 2.).
4 Lift the sanding drum off the floor by turning the lowering
lever at the handle upwards (Fig. 4).
5 Mount the cable support to the console at the top of the
guide tube (Fig. 5).
COMMISSIONING
4
Commissioning
Fig. 4 Lift the sanding drum off the floor by turning the
lowering lever at the handle upwards.
Fig. 2 Insert the guide tube into the opening in the
machine housing (1.). Tighten the wing nut (2.).
Fig. 3 Put the lower rod in the hole of the lifting fixture
(1.) and fix them with the closure (2.).
Fig. 5 Mount the cable support to the console at the
top of the guide tube.
55