Lagler Superhummel, Эксплуатация Обслуживание Безопасность

Страница: 60 / 102

SUPERHUMMEL
01.11.2011
ENGLISH
Fig. 21 To switch off the machine turn the switch button
to position -0-.
Similar to figure.
4
COMMISSIONING
4.3.3 GENERAL
If the motor should ever be difficult to start in extremely cold
conditions proceed as follows::
1 Remove the V-belts ( Section 7.10, Replacement of
V-belts ).
2 Switch on the motor ( Section 4.2.1 and Section 4.2.2 ).
3 Once the motor is up to temperature, switch off the motor.
4 Mount the V-belts and tension the belts using the eye bolt
or cross grip respectively ( Section 7.10, Replacement
of V-belts ).
4.4 SWITCHING OFF THE MACHINE
1 Before switch off the machine lift the sanding drum off the
floor by turning the lowering lever at the handle upwards
(Fig. 12).
2 Turn the switch button to position -0- (Fig. 21).
3 Wait until the sanding drum comes to a standstill before
replacing the machine down onto the sanding drum!
ATTENTION!
Always pull the power plug out of the socket if work is
concluded!
60