Lagler Superhummel, Эксплуатация Обслуживание Безопасность

Страница: 63 / 102

SUPERHUMMEL
01.11.2011
ENGLISH
5
5.3 REGULATION OF THE SANDING PRESSURE
ATTENTION!
Always pull the power plug out of the socket before you
start working on the machine!
The lever for regulation of the sanding pressure (Fig. 22) can be
used to set three different drum pressure stages:
• Lever in upper position: high sanding pressure
• Lever in middle position: middle sanding pressure
• Lever in lower position: low sanding pressure
The sanding pressure should be adjusted in line with the grit size
sequence and reduced as the fineness of the grit size increases.
This setting facility permits you to adjust the drum pressure to
the prevailing circumstances.
In order to avoid dish-outs when sanding soft wood floors, the
sanding pressure should be reduced and the sanding speed
increased.
5.4 EMPTYING THE DUST BAG
ATTENTION!
• To avoid fire or explosive damage, always remove the
dust bag from the machine following sanding and empty
the contents into a non-combustible container!
• Seal this container with a non-combustible cover and
always store both the container and the dust bag in the
open!
• Keep well away from sources of fire!
Do not smoke when there is dust in the atmosphere (e.g.
while working with the machine or emptying out the
dust)
this could cause a dust explosion!
• When emptying the dust bag, a respiratory protection
mask (category P2 at least) must be used!
The dust bag must be emptied when one third full at the latest.
Otherwise, suction performance will deteriorate as the filter
surface becomes clogged.
WORKING WITH THE SUPERHUMMEL
Fig. 22 Regulation of the sanding pressure.
63