Lagler Flip, Эксплуатация Обслуживание Безопасность

Страница: 12 / 60

FLIP
®
01.12.2012
English / Englisch
Fig. 3 Push the dust bag over the locating flange (1.) and
fix it in place with the two metal studs (2.).
4
Commissioning
The section describes how to start using the FLIP
®
on-site. In order
to prevent damage and malfunctions, you must proceed in the order
of steps indicated below.
4.1 PREPARING THE MACHINE
ATTENTION!
Please note that the packaging serves as a transport container
for the machine, accessories and the sanding medium. Fur-
thermore, the machine can be sent back safely in the original
packaging without risk should there be any problems.
1 Unpack the machine carefully. Dispose of the packing materi-
als according to the environmental regulations.
2 Pull out the stop bolt on the suction socket of the fan housing
(Fig. 2, 1.) and at the same time insert the pipe socket into the
fan housing (Fig. 2, 2.).
3 Turn the pipe socket so that the opening of the elbow piece
is facing the back and the stop bolt can snap into place when
it is let go.
4 The pipe socket can be turned 360°. Four fixed positions exist
where the stop bolt can snap into place in the pipe socket.
CAUTION!
RISK OF INJURY and RISK OF PROPERTY DAMAGE:
The stop bolt must always snap into place in the pipe socket!
5 Push the dust bag opening over the locating flange to the
end of the elbow piece (Fig. 3, 1.). Fix the dust bag into place
using the two metal studs (Fig. 3, 2.).
Fig. 2 Pull the stop bolt (1.) and insert the pipe socket
into the fan housing (2.).
COMMISSIONING
12