FLIP
®
01.12.2012
English / Englisch
The machine attempts to start up but is not able to do so
•
At low temperatures: The machine is too cold and must be
heated up to room temperature in a warm room.
•
A cable which is too thin or too long is used for the electrical
connection. Power cables with wire cross-sections smaller
than 1.5 mm² or with a total length of more than 20 m lead to
a loss of power and are not allowed for safety reasons!
•
The electrical network is not providing sufficient voltage
(undervoltage). Use a transformer if necessary (e.g. LÄGLER
®
part number 708.00.00.100 for 230 volts).
•
The V-belt is too tight and must be loosened (
Section 7.2,
Tightening the V-belt
).
The machine has switched off automatically
•
The motor has become too hot and must cool off (due to un-
dervoltage in the power supply or too much pressure on the
attachment while sanding).
•
The wear limit of the carbon brushes has been reached. The
carbon brushes must be replaced (
Section 7.6, Replac-
ing the carbon brushes
)! Use only original LÄGLER
®
FLIP
®
carbon brushes with safety contacts (part number in
Section
11, Spare parts
)!
THE MACHINE RUNS BADLY
The machine runs, but has no or very little sanding power capacity
•
The sanding medium is incorrect or dull and must be replaced
(
Section 5.2, Replacing the sanding medium
).
•
At low temperatures: The machine is too cold and must be
heated up to room temperature in a warm room.
•
A cable which is too thin or too long is used for the electrical
connection. Power cables with wire cross-sections smaller
than 1.5 mm² or with a total length of more than 20 m lead to
a loss of power and are not allowed for safety reasons!
•
The electrical network is not providing sufficient voltage
(undervoltage). Use a transformer if necessary (e.g. LÄGLER
®
part number 708.00.00.100 for 230 volts).
•
The V-belt is not tight enough and must be tightened a bit
(
Section 7.2, Tightening the V-belt
).
•
The machine setting angle is too flat. The guide rollers must
be properly adjusted (
Section 7.8, Adjusting the guide
rollers
).
9
CAUSES OF FAULTS
44
Содержание Flip
