Lagler Flip, Эксплуатация Обслуживание Безопасность

Страница: 27 / 60

FLIP
®
01.12.2012
English / Englisch
Fig. 33 Loosen the screw (1.), turn the belt tightening plate
away from the attachment (2.) and retighten the
screw (3.).
7.3 REPLACING THE V-BELT
Use only original LÄGLER
®
V-belts (part number in Section 11,
Spare parts )!
The V-belt must be replaced, at the latest, when it cannot be retight-
ened because the screws for connecting the attachment are at the
end of the holes.
7.3.1 REMOVING THE V-BELT
1 Switch off the machine.
2 Pull the power plug out of the socket!
3 Lay the machine on its side or with the motor housing on a
table. Avoid damages to the floor and/or table and the ma-
chine.
4 Undo the screw of the belt tightening plate with the universal
spanner (Fig. 33, 1.).
5 Turn the belt tightening plate away from the attachment (Fig.
33, 2.). and retighten the screw of the belt tightening plate
(Fig. 33, 3.).
6 Use the universal spanner to remove the two screws which
connect the attachment, along with the washers and the guide
angles (Fig. 34). Place these parts to the side.
7 Remove the attachment from the machine (Fig. 35) and put
down the attachment with the sanding disc facing upward.
8 Use the universal spanner to undo the fixing screws of the
attachment cover and remove this from the attachment
(Fig. 36).
9 Turn the attachment over.
MAINTENANCE WORK AND REPLACEMENT OF WEARING PARTS
7
Fig. 34 Remove the two screws which connect the
attachment, along with the washers and the guide
angles.
Fig. 35 Remove the attachment from the machine.
Fig. 36 Remove the attachment cover from the attach-
ment.
27