Lagler Flip, Эксплуатация Обслуживание Безопасность

Страница: 29 / 60

FLIP
®
01.12.2012
English / Englisch
Fig. 41 Insert the V-belt into the motor pulley.
7 Tighten the two screws for connecting the attachment, plac-
ing a washer and guide angle in the respective threads of the
fan housing (Fig. 42, 1.). Do not tighten the screws yet.
WARNING!
HEALTH RISK caused by dust:
Make sure that the belt tightening plate is not located between
the attachment and the fan housing (Fig. 42, 2.)! Otherwise, a
significant amount of dust will escape from this area during
sanding!
8 Tighten the V-belt ( Section 7.2, Tightening the V-belt ).
Checking the belt tension again after break-in time of a few days
and tighten the V-belt again if necessary!
7.4 REPLACING THE COMPLETE SANDING PLATE
Use only original LÄGLER
®
sanding plates (part number in Section 11,
Spare parts )!
If it is determined while replacing the V-belt that the sanding plate
pulley is worn-out, the complete sanding plate must be replaced
as follows:
1 Switch off the machine.
2 Pull the power plug out of the socket!
3 Remove the attachment from the machine and dismantle the
complete sanding plate ( Section 7.3.1, Removing the V-
belt ).
4 Put the attachment with a new complete sanding plate back
on the machine ( Section 7.3.2, Installing the V-belt ).
MAINTENANCE WORK AND REPLACEMENT OF WEARING PARTS
7
Fig. 42 Turn both screws for connecting the attachment
and place a washer and a guide angle in the
respective thread of the fan housing (1.). Make
sure that the belt tightening plate is not located
between the attachment and the fan housing (2.)!
29