Kyocera Mita Ecosys FS-1800, Руководство пользователя

Страница: 87 / 249

Operating the Operator Panel
1-77
Setting the RAM Disk
A RAM disk can be set up as a virtual media device by setting a given
amount of the total printer memory as the RAM disk. (This is only
available for the FS-1800 when the printer's memory has been expanded to
12 MB or more.) By setting up a RAM disk electronic sorting can be done.
(This cuts down the total time of printing.) Note however that data written
to the RAM disk is lost if the power to the printer is turned off or the
printer is reset. RAM disk settings can be made from the printer's operator
panel.
• The RAM disk is set from the printer's user memory. The printer's
printing speed may therefore drop or insufficient memory errors
result depending on the value of the RAM disk setting.
• RAM disk functions cannot be used if an option hard disk
(Microdrive) is installed.
1
Press the MENU key.
2
Press the
or
key and select
RAM Disk Mode >
.
3
The default setting is
Off
. Pressing the ENTER key will cause a
?
to
blink. Press the
or
keys to display On and then press the
ENTER key.
4
Press the > key to display
>RAM Disk Size
.
5
Press the ENTER key again, and change the RAM disk size using the
or
key. It is not possible to make a setting that exceeds total
printer memory. The default value for the RAM disk is the total
printer memory minus 9 MB. This parameter may be set anywhere
from
01
to
99
depending on the available printer memory.
Press the CANCEL key if you want to cancel the setting.
RAM Disk Mode >
Note
MENU
RAM Disk Mode >
Off
ENTER
RAM Disk Mode >
? Off
?
>RAM Disk Size
Mbyte
ENTER