KYLAND Technology KIEN6000, Руководство пользователя

Страница: 33 / 48

Kyland Telecom
-27-
Use 24V DC power supply for KIEN6000 equipment according to the
indications on product label. Connect power supply after completing
connection for all other cables.
4.4 Optical fiber connection
KIEN6000 provides 2 pairs of redundant 100Base-FX full duplex single mode or
multi-mode optical fiber interfaces. These optical fiber interfaces can be used to form
an optical fiber redundant ring network. In case an equipment or optical fiber cable at
some point fails, the network can recover within 300ms. SC or FC optical fiber
interface can be selected according to actual needs.
Warning:
This switch uses laser to transmit signal on optical fiber cable. The laser meets class 1
laser product requirements and harmless to eyes under normal operation. However,
when the equipment is switched on, do not stare directly into the optical fiber
transmitting interface and the end of optical fiber terminator.
Connect pluggable optical fiber module according to the following procedures:
1
．
Remove and keep the rubber sleeve of SC or FC port. When it is not in use,
cover SC or FC port with the rubber sleeve to protect the optical fiber terminator.
2
．
Check whether the optical fiber terminator is clean. Slightly wet a clean tissue or
cotton ball and carefully wipe cable plugs. Contaminated If the optical fiber
terminator is contaminated, transmitting quality of optical fiber will reduce,
affecting port performances.
3
．
Connect one end of optical fiber cable to the optical fiber interface of the switch
and the other end to the optical port of another equipment as shown in Figure
4-6.