KYLAND Technology KIEN6000, Руководство пользователя

Страница: 37 / 48

Kyland Telecom
-31-
5.3 Testing of optical fiber interface
Let the equipment of KIEN6000 at both ends to form a fiber link network as shown in
Fig. 5-2., connect any one Ethernet interface of each equipment to the testing
computer by straight-through network cable, transmit Ping command mutually, both
sides can correctly Ping to each other and no data package is lost. At the same time, the
LINK/ACT lamp of the corresponding optical port should light. This indicates the tested
hardware of the two electrical operates normally. The same testing method will be used
to test the other pair of optical ports (For detailed operation of the Ping command,
please refer to the following examples).
Figure 5-2 Optical port testing
Example of PING command:
The IP address of testing computer 1 is 192.168.100.10, and that of the testing
computer 2 is 192.168.100.11
，
operating command in the “Operation” column of the
“Starting” menu of the operating testing computer 1 is cmd or command (WIN2000
system uses cmd, WIN98/95 uses command respectively), transmitting ping is
192.168.100.11 –l 1000 –t (–l refers to the number of byte, -t means continuously
transmitting data), operating command in the “Operation” column of the “Starting”
menu of the operating testing computer 2 is cmd or command (WIN2000 system uses
cmd, WIN98/95 uses command respectively), transmitting ping is 192.168.100.10 –l
1000 –t , testing computer 1 replies from 192.168.100.11 ： bytes=1000 time<10ms
TTL=128, testing computer 2 replies from 192.168.100.10
：
bytes=1000 time<10ms
TTL=128. If the lost package rate is 0 based on the statistic by using CTL+C command
after the operation is over 10 minutes, this indicates that the operation is normal.