KYLAND Technology KIEN6000, Руководство пользователя

Страница: 14 / 48

Kyland Telecom
-8-
2.3 Service function
Configuration and Management
At KIEN6000, the settings, queries and management can be realized for the whole switch or network
system through CONSOLE interface.
LED Indicator
The LEDs indicate the port status correctly including transmission rate, link status and system status.
VLAN
The network can be divided into several VLANs according to ports, through which the users in one VLAN
can communicate each other. The VLAN of KIEN6000 conforms to IEEE802.1Q and can realize the
communication within one VLAN of different switches. KIEN6000 supports up to sixteen VLANs based
on IEEE802.1Q.
802.1p Prioritization
KIEN6000 conforms to 802.1p, which is used the most widely in LAN environment. The end-users of
KIEN6000 can make use of this function to configure the port-based prioritization when 802.1p is not
supported at user’s end and different priority is necessary for different ports’ services. Only the data
package without Prioritization in the Packet in the ports can be affected by this function. Each port of
KIEN6000 supports 2 levels (high, low) prioritization.
Layer-2 Switching
Switches work in two ways: Cut-Through and Store-and-Forward. In Cut-Through, a data packet is
immediately relayed further after detecting the target address; in Store-and-Forward, a data packet is
first read-in completely and checked for errors before the switch relays the same. KIEN6000 employs
Store-and-Forward that is a switching mode widely used.
IGMP
IGMP means Internet Group Multicast Protocol. KIEN6000 supports IGMP surveillance and inquiry.
Port Trunking Function
Each logical port has same speed rate 、 duplex and VLAN ID in KIEN6000.
Setting for Working Mode of Port
KIEN6000 is able to set the wo rking mode of all ports through management: full/half duplex,
auto-sensing, enforced full/half duplex, enforced 10M/100M etc.
Broadcast Storm Control