Kurzweil K2661, Справочник музыканта

Страница: 58 / 500

6-4
MIDI, SCSI, and Sample Dumps
The MIDI Sample Dump Standard
The MIDI Sample Dump Standard
Samples can be transferred between the K2661 and most other samplers and computer sampling
programs using the MIDI Sample Dump Standard.
Due to the relatively slow transfer rate of MIDI data, transferring samples into the K2661 via the
MIDI Sample Dump Standard can take a long time, on the order of a coffee break for a large
sample. Most samplers, synthesizers, and software will “freeze up” during this process,
preventing other features of the machine or program from being used. Your K2661, however,
will allow you to continue playing the instrument or using any of its sound editing features
during a MIDI Sample Dump! The transfer takes place in the background; the MIDI-mode LED
on the K2661’s front-panel
fl ashes repeatedly during the transfer, so you will always know if the
MIDI Sample Dump is proceeding. The MIDI-mode LED fl ashes only when the K2661 is
transmitting or receiving a MIDI Sample Dump, or when it receives a MIDI System Exclusive
message.
Note : if you’re using Sound Designer
®
to transfer samples, you’ll have to offset the sample
number by 2 to transfer the right sample. For example, if you want to dump sample ID 208 from
the K2661, then when you begin the sample fetching command from Sound Designer, instruct it
to get sample 210.
Loading Samples with the MIDI Standard Sample Dump
To load a sample into the K2661 from an external source such as a computer or sampler, fi rst
connect the MIDI Out port of the sampler (or computer) to the K2661’s MIDI In port, and
connect the K2661’s MIDI Out to the MIDI In of the sampler. This is known as a MIDI loop.
Next, access the Sample Dump facility on the sampler. In addition to selecting which sample
you wish to transfer over MIDI, you will need to set the correct sample dump channel number
and destination sample number. The channel number should match the K2661’s SysEx ID
parameter (on the RECEIVE page in MIDI mode). If the sampler has no facility for setting the
Sample Dump channel number, try setting the K2661’s SysEx ID parameter to
0 or 1 .
Alternatively, if you set the SysEx ID to 127 , the K2661 will accept a MIDI Sample Dump no
matter what Sample Dump channel is used to send the sample dump.
If the sampler has a provision for setting the destination sample number, you can use it to
specify the ID the K2661 will use for storing the sample. The K2661 sample number is mapped
from the destination sample number as follows:
If the sample number maps to a number already assigned to a RAM sample in the K2661, the
RAM sample will be deleted before the K2661 loads the new sample. The K2661 will always
map sample number zero to an unassigned ID, and therefore no samples will be overwritten
when zero is speci
fi ed.
Sample Number K2661 ID
0 uses lowest unassigned ID between 200 and 999.
1-199 adds 200 to the ID (for example, 5 becomes 205 in the K2661.)
200-999 ID is the same number.