Kurzweil K2661, Справочник музыканта

Страница: 258 / 500

10-176
KDFX Reference
KDFX Algorithm Specifications
Figure 92 Revrse LaserVerb
Parameters:
Page 1
Page 2
Wet/Dry The amount of reverbed (wet) signal relative to unaffected (dry) signal.
Rvrs W/D A special wet/dry control in which the “dry” signal is in fact delayed so that it is the last
sound to be sent to the output, as if the LaserVerb is being played in reverse.
Out Gain The overall gain or amplitude at the output of the effect.
Pan The left and right inputs get summed to mono, the mono signal passes through the Revrse
LaserVerb , and the fi nal mono output is panned to the left and right outputs. Panning
ranges from -100% (fully left), through 0% (centered), through to 100% (fully right).
Dly Coarse You can set the overall delay length from 0 to 5 seconds. Lengthening the delay will
increase the duration or decay time of the reverb.
Dly Fine The delay fi ne adjust is added to the delay coarse adjust to provide a delay resolution
down to 0.2 ms.
Spacing Determines the starting pitch of the ascending buzz and how fast it ascends. The Spacing
parameter sets the initial separation of impulses in the impulse response and subsequent
rate of decreasing impulse separation. The spacing between impulses is given in samples
and may be a fraction of a sample. (A sample is the time between successive digital words
which is 20.8 µs or 1/48000 seconds.) For low values, the buzz builds to a higher
frequency than for higher Spacing settings.
Wet/Dry 0 to 100 %wet Out Gain Off, -79.0 to 24.0 dB
Rvrs W/D 0 to 100 %wet Pan -100 to 100 %
Dly Coarse 0 to 5000 ms Contour 0.0 to 100.0 %
Dly Fine -20.0 to 20.0 ms
Spacing 0 to 200 samp
L Input
R Input
Delay
Pan
"Dry"
Wet
Out Gain
Contour
L Output
R Output