Kurtz Ersa HR 550 XL, Перевод оригинального руководства по эксплуатации

Страница: 58 / 157

6 | Function description
Overview of the machine parts
1 RPC camera, optional 5 mega-
pixels
12 Visionbox, contains component
camera and PCB camera
2 Clamp lever for the optional RPC
camera
13 Connections for ESD wrist band
3 Lever for moving in/out the Vis-
ionbox
14 PCB holder, removable
4 Left component tray, also for Dip
& Print stencil
15 Handle to remove the PCB frame
5 Main switch, machine On/Off
The ON indicator light on the con-
trol unit (22) indicates if the Re-
work system is switched on.
16 Locking screw for PCB holder
6 Heating head with motorized
height adjustment
17 Red warning light: Caution Burn
hazard Hot machine parts or PCB!
7 Sliding lever for heating head re-
moval
18 Cross table, motor adjustable
8 Key to rotate the pipette (8)
clockwise and counterclockwise.
Rotation angle and speed select-
able via key functions. These keys
are also located on the control
unit.
19 Bottom heating with 4 x 2 heating
zones
The area that can be reached by
the heating head, the pipette and
the top camera is the full-width
back half.
9 Pipette with motorized height ad-
justment and touch sensor.
20 Cooling air leakage after the sol-
dering process
10 Right component tray, also for Dip
& Print stencil
21 Connection sockets for thermo-
couples 1-3
11 Lever for switching the Visionbox
from normal view (lever out) to
Zoom / Tele (lever in)
22 Control unit
NOTE
Use safety shoes as personal protective equipment!
The control unit may fall down at any time when operating the Rework system. There-
fore, strictly comply with the following safety instruction:
safety shoes must always be worn when performing work on the Rework system:
Ersa GmbH Operating instructions HR 550 XL EN 3BA00247-01 | Rev. 1 58 / 157