Kendrion Kuhnke Automation GmbH
System description
17
11/25/2016
1
2
Figure 6: Uninstalling a module
1
2
3
3.2.2.2 Installation order within a FIO system
NOTE
To ensure smooth function of the entire FIO system, the FIO modules must be arranged based
on their e-bus load. The modules with the biggest e-bus load are to be arranged directly next to
the head modules (bus coupler or controller). Make sure that you note the maximum bus load of
the head module. Kuhnke FIO Safety I/O shall be arranged directly next to the head module.
3.2.2.3 To snap on a single module
1. Push up the module against the mounting rail from below,
allowing the metal spring to snap in between mounting rail
and mounting area as illustrated.
2. Push the module against the mounting wall until is snaps in.
3.2.2.4 To interconnect two modules
•
After snapping on the first module to the rail, snap on the second module about 1cm
away towards the right of the first module.
•
Push the second module along the rail towards the first module until you hear the locking device
snap in.
3.2.2.5 To disconnect two modules
•
Push down the unlock button (see Figure 6) of the module that you wish to disconnect from the
module to the left of it.
•
Push both modules away from one another until they are about 1 cm apart.
3.2.2.6 To take down a single module
1. Push the module up and against the metal spring located on the
underside of the rail guide.
2. Tip the module away from the rail as shown in the illustration.
3. Pull the module down and out of the mounting rail.
Das verknüpfte Bild kann nicht angezeigt werden. Möglicherweise wurde
Figure 5: Rail mounting of module
Unlock button
