SR600 GII
28
6. - Putting into service
7N037CUS_B
Wheel Rake
6.1.5 Safety chain
Pass the end link through the holes on the tongue
(1), then pass the hook through the end link. The
hook end should then be pulled forward through the
intermediate support (2) (if required) on the towing
machine's drawbar, and around the towing
machine's attaching point (3), hooking back to the
safety tow chain itself.
If distance (X) from the towing machine's attaching
point to the draw pin (4) is more than 9’’ (23 cm), an
intermediate support (2) capable of withstanding
one half the required chain capacity is required.
When in use the safety tow chain should have no
more slack than necessary to permit proper
articulation of the implement.
The safety tow chain should be stored to prevent
damage from weather or improper use when not in
use with the machine. Check chain condition and
replace it with a new one if necessary.
The safety chain is intended to keep the
machine under control in the event of a loss
or failure of the hitching device.
Do not use the intermediate support as the
attaching point.
The safety tow chain must be replaced if any
one link is broken, stretched, or otherwise
damaged or deformed.
Safety chains are sold separately. Contact your
Kuhn dealer to purchase a safety chain for your
specific machine.
3
2
4
1
X
