FC244R / FC244R HD
50
6. - Putting into service
KN330CGB_A
Mower conditioner
- Separate the two half PTO shafts and connect
them to the machine's input shaft and to the tractor
PTO stub.
- Check the length of the PTO shaft:
• When the PTO shaft is in its maximum overlap
position (retracted), tubes should not butt against
the yokes. There must still be a minimum safety
travel (L) of 25 mm (1’’).
•
When extended to the maximum, the tube
overlap must not be below 250 mm (10’’).
If this is not the case:
- Mark length (H) to cut when the transmission is the
maximum overlap position.
- Shorten the guard tubes and the transmission
tubes by the same length.
- Bevel and clean the tubes.
- Grease the inside of the outer tube.
L
H
L
