10. - Maintenance and storage
FC244R / FC244R HD
101
KN330CGB_A
Mower conditioner
When remounting:
- Position their largest diameters at right angles to
each other.
- Position conical centre of spring washer at the
top.
- Tighten screws:
• Torque: 12 daNm (89 lbf ft).
Check if there is still a minimum gap X = 1 mm
(0.04’’) between the disk lower part and the
cutter bar wear plates.
If this is not the case, fit one (maximum two)
spacer(s) between the disc and the mounting
hub.
X
When the following equipment is fitted:
"HD" discs.
