KTR-STOP
®
XS-A-F B-xx
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
445118 EN
21 of 23
1
Please observe protection
note ISO 16016.
Drawn:
2020-12-03 Shg/Mro
Replacing:
---
Verified:
2020-12-03 Shg
Replaced by:
•
Set the gap between brake disk and brake pad to 0.5 mm or the requested value x (see illustration 20) by
screwing the hexagon nut marked with 1 in illustration 21 upwards or downwards.
•
Counter the hexagon nut with the hexagon nut marked with 2 in illustration 21.
•
Push the pressure spring (component 4.2) and the disk (component 4.4) onto the pin of the centering system.
Screw the two hexagon nuts (component 4.3) until they fit the disk.
•
The pressure spring needs to be pre-stressed by 5 mm. Counter the hexagon nut with the hexagon nut
marked with 4 in illustration 21.
•
Repeat chapters 4.2 to 4.8.
Illustration 20: Setting of gap
Illustration 21: Setting of centering system
KTR-STOP
®
XS-A-F B-xx
is a low-maintenance brake. We recommend to perform a visual inspection and an
operational testing on the brake
at least once a year
. Here you should put special emphasis on leakages, corro-
sion, wear of brake pads and the condition of the screw connections.
If you realize any irregularities, please perform repairs accordingly.
5
Maintenance
5.2 Maintenance of the brake / replacement of single parts
5.3 Maintenance and service
