KTR-STOP
®
XS-A-F B-xx
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
445118 EN
11 of 23
1
Please observe protection
note ISO 16016.
Drawn:
2020-12-03 Shg/Mro
Replacing:
---
Verified:
2020-12-03 Shg
Replaced by:
Secure the screw connection (component 5.1) on the brake pad additionally against working
loose, e. g. conglutinating with Loctite (average strength).
•
Mount the spring clamps (component 6).
•
Insert the brake in the correct position to the
connection plate. Hand-tighten the brake via the
screws first.
Illustration 9
To facilitate the assembly it is pos-
sible to fix the position of the brake
by one screw only first. Swing in the
brake until the balance of the screws
can be assembled, too (see illustrati-
on 9).
•
Screw the brake to the connection plate by means
of 2 screws and tighten them evenly gradually at
the tightening torque specified (see table 4).
Table 4: Tightening torques
Screw size
Tightening torque T
A
[Nm]
10.9
12.9
Untreated and oiled
Greased with MoS
2
Untreated and oiled
Greased with MoS
2
M16
290
215
340
250
•
Align the brake in centre to the brake disk.
•
Make sure that the brake disk can rotate freely while not touching the brake pads or the housing.
In order to avoid any contact between the brake disk and the brake resulting from thermal
expansion, the distance of the brake as per table 3 needs to be observed.
!
Make sure that the tolerances of the brake disk do not exceed the figures specified in illust-
ration 3.
•
Applying with the use of a sensor only:
Mount the sensor (component 9) according to chapter 6.2.
4
Assembly
4.4 Assembly of the brake
