KTR-STOP
®
XS-A-F B-xx
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
445118 EN
10 of 23
1
Please observe protection
note ISO 16016.
Drawn:
2020-12-03 Shg/Mro
Replacing:
---
Verified:
2020-12-03 Shg
Replaced by:
KTR supplies brake pads free from asbestos and lead only.
If requested, we will provide you with the corresponding certificates.
The brake pads are each adapted to the application and delivered accordingly.
They can be distinguished as follows:
•
organic material
•
sinter metal
!
Brake pads are highly sensitive to grease and oil which means that they cannot be cleaned.
Brake pads having such kind of dirt need to be replaced and disposed of.
We would recommend to store the brake pads in their package as long as possible to pro-
tect them from any kind of dirt.
!
Brake pads which have worn off to the wear limit have to be replaced immediately. Make
sure to replace by original parts only.
STOP
In order to avoid any injuries please always make use of proper lifting equipment.
A thread M8 is located on the back of the brake to fasten an eye bolt serving to use lifting tools. The eye bolt is to
be dismounted after assembly of the brake and stored in a safe place.
!
In order to avoid any damages on the brake, never twist a rope or any other lifting tool
around damageable components such as sensors, centering systems, etc.
Before you start with the assembly please check if a sensor has been mounted.
Please remove it before assembly in order to avoid any damages.
•
Insert the brake pads (component 8) fully into the brake caliper.
•
Applying for the moveable side only:
Push back the brake pad and brake piston manually.
!
Please make sure that at least one screw plug (component 1.6) is removed when moving
back the brake piston. Afterwards re-assemble the screw plug.
If you want to use brake pads after having assembled the brake, it is necessary to disas-
semble the pad retainer (component 1.3 and 1.4) for that purpose (chapter 5.1).
•
Mount the pad retraction set for housings (component 5) by shifting the pressure spring (component 5.2) with
the disk (component 5.3) onto the sleeve (component 5.4). Screw the hexagon screw (component 5.1) with the
pressure spring, the disk and the sleeve into the brake pad against a stop.
4
Assembly
4.3 Brake pads
4.4 Assembly of the brake
