KTM TRILINE, Руководство по эксплуатации и обслуживанию, Страница: 22 / 135

Section 2
Installation
72183178
4-2016/Rev 0
ORIGINAL INSTRUCTIONS 2-8
Measurements and Dimensions
Tubing must be cut to the proper length, both ends of the tubing must then be coned, threaded and
deburred.
To determine the tube length, measure the distance between the fittings, and add two times the
engagement allowance shown in Table 2-5. Table 2-6 lists the required cone and thread
dimensions illustrated in Figure 2-4.
Table 2-5
Engagement Allowance (EA)
1/4” Tubing 0.49” (12.4 mm)
Figure 2-3: Tube Length
3/8” Tubing 0.68” (17.3 mm)
9/16” Tubing 0.86” (21.8 mm)
Figure 2-4: Cone and Thread Dimensions
Table 2-6
Cone and Thread Dimensions
Tube OD Tube ID
D
(Maximum)
L
(Maximum)
Thread
UNF-LH
1/4” (6.35 mm) 0.083” (2.11 mm) 0.125” (3.2 mm) 0.562” (14.3 mm) 1/4” - 28
3/8” (9.52 mm) 0.125” (3.18 mm 0.219” (5.6 mm) 0.750” (19.1 mm) 3/8” - 24
9/16” (14.29 mm) 0.188” (4.78 mm) 0.281” (7.1 mm) 0.938” (23.8 mm) 9/16” - 18