Krone Round Pack 1250, Оригинальная инструкция по эксплуатации

Страница: 57 / 136

V - 23
Basic Settings and Operation
5.7.7 Selecting the number of bale wraps
(Medium)
The adjusting screw (2) for setting the number
of bale wraps has a left-handed thread!
The number of times the bales are wrapped can be set on
the right-hand side of the machine on the adjusting screw
(2). The point (3) of the spring bar should not be positioned
on the adjusting screw. Insert an Allen key into position (4)
on the adjusting screw and unfasten the counter nut (1)
(please note - left-handed thread). The adjusting screw can
be turned by using the Allen key. The further the screw is
turned, the more often the round bales are wrapped.
Retighten the counter nut securely after adjustment.
The measurement "a" = distance from the insertion point of
the spring bar tipto the end of the adjusting screw.
Check the values on a finished bale and correct them if
necessary.
1
2
3
4
3
a
RP600002
5.7.8 Adjusting the spring bar
The proper function of the net wrapping mechanism is only
ensured if spring bar (1) is lifted over set screw (2). This
adjustment is carried out at the factory.
Due to wear of the V-belt of the tensioning device it can be
necessary to readjust the lifting stroke of the spring bar.
For this:
• Release the bolts (3).
• Move guide (4) relative to slotted hole (a) until spring
bar (1) is above set screw (2).
• Tighten the bolts (3).
1
RP600001
3
2
4
a
Distance "a" [mm]
Number of
wraps
RP 1250 RP 1550
19 23 2
28 34 3