Krone Round Pack 1250, Оригинальная инструкция по эксплуатации

Страница: 37 / 136

V - 3
Basic Settings and Operation
Cutting length Number of blades Setting
– 0 “0”
128 mm 7 “7”
64 mm 15* “15”
64 mm 17 “17”
5.3 Cutting System (MultiCut)
5.3.1 Special Safety Instructions
The following general rules apply to all maintenance, assembly, repair and adjustment work:
• Bring the round baler to a complete standstill.
• Switch off the motor, remove the ignition key and disconnect the 12 V supply voltage.
• Secure the tractor and round baler against rolling.
• Risk of injury when attaching or removing the blades. Always wear suitable gloves when
handling the blades.
• When working inside the bale chamber, make sure to secure the open tailgate at the shut-off
tap to prevent it from falling.
5.3.2 General Information
The cutting system consists basically of a blade rotor and
17 blades. Cutting helps to improve further processing of
the round bale and increase bale density.
Should clogging occur, the blades can be slewed out of the
feed channel hydraulically.
The blade safety mechanism prevents the blades from
being damaged by foreign objects.
It is also possible to switch off the cutting system
mechanically.
5.3.3 Adjusting Cutting Length
The cutting length is determined by the number of blades
used.
The number of blades used is indicated by the setting on
the selector disc (1).
* The two outer blades are switched off.
VP-1-058
1
"0"
2