Start-up – John Deere
45
Pos : 16.24 /Ü berschriften/Ü berschriften 2/A-E/Ankuppel n @ 16\mod_1233156207726_78.doc @ 180144
5.6
Coupling
Pos : 16.25 /BA/Inbetri ebnahme/Vors ätz e/M aisgebiss/J ohnD eere/Ankuppel n J ohn D eere T1 @ 16\mod_1233240297907_78.doc @ 181254
Fig. 25:
•
Before moving the forage harvester forward, open the protective cover (4).
•
Move the forage harvester up to the maize header so that the feed drive housing (1) of
the forage harvester is directly in front of the adapter frame (2).
•
Lower the feed drive housing until the holding bracket (3) is positioned under the cross-
pipe (10) of the support panel of the maize header.
Pos : 16.26 /BA/Inbetri ebnahme/Vors ätz e/M aisgebiss/J ohnD eere/Ankuppel n J ohn D eere T2 @ 16\mod_1233240428485_78.doc @ 181277
ECF00123
3
11
6
9
8
5
7
5
II
I
12
10
Fig. 26:
•
Move the forage harvester forward until the holding brackets (3) engage behind the
cross-pipe (10) of the maize header support panel.
Note
Make sure that the holding brackets (3) are resting correctly behind the cross-
pipe of the maize header support panel and between the knotting (11) and the
limit stop (12).
•
Raise the feed drive housing with the lifting hydraulics until the lower locking pins (5) are
in front of the bore hole for the maize header’s holder (6).
•
Stop the machine.
•
Align the holders (6) and tighten the screws (7)
(only required when first being placed
in service or when changing forage harvester)
.
•
Lock the locking pins (5) in place.
To do this:
•
Remove the linch pin (8) and move screw (9) from pos. I to pos. II. Lock in place with
linch pin (8).
Pos : 16.27 /BA/Inbetri ebnahme/Vors ätz e/M aisgebiss/J ohnD eere/Ankuppel n J ohn D eere T3 @ 16\mod_1233240649376_78.doc @ 181300