kozy heat MINNETONKA 55345-RF, Инструкция по установке и эксплуатации

Страница: 53 / 67

FINALIZING THE INSTALLATION
FLAME APPEARANCE:
Flame appearance is affected by several factors including altitude, venting configuration and fuel quality. Although the venturi setting has
been factory set, adjustments may be necessary for optimal performance and visual aesthetics.
When fireplace is first lit, the flames will be blue. The flames will gradually turn yellowish-orange during the first 15 minutes of opera-
tion. If the flames remain blue or the flames become dark orange with evidence of sooting (black tips), the burner tube venturi may need
to be adjusted.
WARNING: BURNER TUBE ADJUSTABLE VENTURI POSITIONING SHOULD ONLY BE PERFORMED BY A QUALIFIED
PROFESSIONAL SERVICE TECHNICIAN.
FACTORY SET BURNER TUBE VENTURI SETTINGS
(ADJUST AS NECESSARY FOR YOUR INSTALLATION)
NATURAL GAS LP (PROPANE) GAS
100% CLOSED 100% OPEN FRONT BURNER
BACK BURNER 1/8” (3 mm) OPEN 100% OPEN
BURNER TUBE VENTURI ADJUSTMENT GUIDELINES
VENTURI POSITION FLAME COLOR VENTURI ADJUSTMENT
Closed too far Dark orange flame with black tips Open venturi setting slightly
Open too far Blue flames Close venturi setting slightly
NOTE: IF SOOT IS PRESENT, CHECK LOG POSITIONING BEFORE ADJUSTING BURNER VENTURI. LOGS MUST NOT
BLOCK BURNER PORTS.
WARNING: TO AVOID PROPERTY DAMAGE OR PERSONAL INJURY,
ALLOW FIREPLACE AMPLE TIME TO COOL BEFORE MAKING ANY
ADJUSTMENTS
.
IMPORTANT: SLIGHT ADJUSTMENTS TO THE BURNER VENTURI OPENING CREATE DRAMATIC RESULTS. ADJUST AT
SLIGHT INCREMENTS UNTIL DESIRED LOOK IS ACHIEVED. ALWAYS BURN FIREPLACE FOR AT LEAST 15 MINUTES AND
ALLOW TIME TO COOL BEFORE MAKING ANY FURTHER ADJUSTMENTS.
1. Remove set screw securing venturi wheel (located under firebox).
2. Moving handle towards #1 position closes venturi opening.
Moving handle towards #9 position opens venturi opening.
3. Re-install set screw.
4. Light fireplace and wait 15 minutes before determining if
any further adjustments are needed.
TO ADJUST BACK BURNER VENTURI:
PAGE 50
TO ADJUST FRONT BURNER VENTURI:
1. Follow Millivolt Board Removal instructions on page 35 to access
and remove front burner assembly.
2. Loosen screw on venturi and adjust as necessary. Tighten screw.
3. Follow Millivolt Board Installation instructions on page 36 to reinstall
all components.