kozy heat MINNETONKA 55345-RF, Инструкция по установке и эксплуатации

Страница: 49 / 67

IMPORTANT:
On the initial use of the transmitter, a recognition operation is
required between the receiver / valve and the transmitter.
1. Turn gas control knob to the PILOT
position. Move LOCAL / REMOTE
switch to the LOCAL position for at
least two (2) seconds, then move
switch to the
REMOTE position.
2. Press FAN or FLAME button on the
transmitter within thirty (30) seconds
of the switch change.
55345-RF LIGHTING AND SHUTDOWN (cont.)
The LED will blink, indicating that the transmitter will now work with the receiver / valve. If the switch stays in
the REMOTE position, the TR8220A Transmitter will control the main valve, flame modulation level and fan
control.
If the
LOCAL / REMOTE switch is in the LOCAL position, the receiver / valve will be at the highest setting.
LOCAL SETTING: Turn control knob clockwise to the PILOT position.
REMOTE SETTING: The TR8220A transmitter can shut off the main burner and fan. However,
the control is still „ON‟ and a command from the transmitter can turn on the main burner and fan.
1. Open lower grill to access the gas valve & controls.
2. Turn gas control knob clockwise to the
OFF position. This closes the main gas and safety valves.
The transmitter cannot turn on the main burner or the fan.
TURN THE BURNER OFF
TURN THE SYSTEM OFF
NOTE: This control valve has an interlock device. If
pilot has been turned off, it cannot be relit until the
thermocouple has cooled, (approximately 60 seconds).
INITIAL USE OF TRANSMITTER
WITHIN
30 SECONDS
2 SECONDS
OR PRESS
1.
2.
3.
Turn gas control knob to the ON position.
NOTE: If the manual switch is in the LOCAL position,
the main burner will turn on immediately
.
3.
PAGE 46