kozy heat MINNETONKA 55345-RF, Инструкция по установке и эксплуатации

Страница: 14 / 67

MINIMUM FINISHED OPENING DIMENSIONS
FRAMING
WALL ENCLOSURE ROUGH OPENING
IMPORTANT: Framing dimensions should allow for wall covering thickness and fireplace facing materials. If using a hearth, adjust
rough opening size as necessary to maintain at least the minimum clearance requirements.
IMPORTANT: NON-COMBUSTIBLE FACING MATERIAL MAY BE APPLIED OVER (BUT NOT DIRECTLY TO) FIREPLACE FACE. THIS WILL
PREVENT THE FACING MATERIAL FROM FALLING OFF DUE TO EXPANSION OF THE FACE WHEN HEATED. DO NOT OBSTRUCT THE
FLOW OF VENTILATION AIR.
(APPLIES TO BOTH HORIZONTAL AND VERTICAL VENTING TERMINATIONS)
44-1/2”(1130 mm) High x 41-3/8”(1051 mm) Wide x 21-7/8” (556 mm) Deep.
1/2” (13 mm) clearance at back and sides of fireplace must be maintained.
NOTE: Provide adequate clearance in front of fireplace to operate lower grill, open and close optional decorative doors / full door faces,
access the control valve, installation of gas line, fan, etc.
PAGE 11
WARNING: DO NOT OBSTRUCT UPPER AND LOWER GRILL OPENINGS. ROOM AIR ENTERS THROUGH THE LOWER PASSAGE, IS HEATED
AND EXITS THROUGH THE UPPER PASSAGE. BLOCKING THESE PASSAGES MAY RESULT IN OVERHEATING, CREATING A POTENTIALLY
HAZARDOUS SITUATION.
12- 1/2” x (318 mm) H x 10 - 7/8” (277 mm) W opening
(required for horizontal terminations)
44- 1/2”
(1130 mm)
41- 3/8”
(1051 mm)
Hearth
Height
IMPORTANT: Framing dimensions, clearances to combustibles above and below fireplace along with mantel clearances and framed
opening location for horizontal venting differ if installing the optional #MTK-CFK Minnetonka Clean Face Kit.
Please refer to instructions included with kit.
21- 7/8”
(556 mm)
Illustration at right requires a minimum 5” (127 mm)
exterior wall depth when using minimum horizontal venting.
Anything less than a 5” (127 mm) exterior wall depth requires
that you add that depth to the 21-7/8” (556 mm) dimension to
accommodate minimum venting.
*
5” (127 mm) exterior wall depth shown*