Kontron KBox C-102 Series, Руководство пользователя

Страница: 64 / 144

KBox C-102 - User Guide, Rev. 1.0
www.kontron.com // 64
10.2. Preventive Maintenance for SSD Drives
This section applies to all mSATA and SSD devices installed into the KBox C-102 system.
Because of the limited predetermined lifespan of the mSATA/SATA SSD devices, we
recommend to check the condition of your installed SSD drives via S.M.A.R.T. regularly.
Pay attention to the manufacturer specifications for lifespan.
For replacing of these devices refer to the sections: 4.4.12 and 6.3.7.
10.3. Replacing the Fan Tray
The operation of the KBox C-102 versions with fan tray extension is permitted only with a
functional fan tray!
Defective components may only be replaced by Kontron original spare parts:
 Part number of the fan tray: 9-5000-1096 for KBox C-102-4
 Part number of the fan tray: 9-5000-1095 for KBox C-102-2
 Part number of the fan tray: 9-5000-1094 for KBox C-102-1
The fan tray can be replaced during operation. This should only be carried-out by qualified
personnel aware of the associated dangers.
The fan will not stop immediately when the fan tray is removed during operation. Pull out
the fan tray only a few centimeters and wait until the fan comes to stop.
To replace fan tray, proceed as follows:
1. Ensure to have access to the bottom side of the KBox C-102-4/-2/-1. The fan tray (Figure 52, pos. 1 and Figure 53,
pos. 2) may be replaced without removing the air filter holder (Figure 52, pos. 4).
2. Loosen the two knurled screws (Figure 52, pos. 2) of the fan tray.
3. Pull the fan tray (Figure 53, pos. 2) out from the fan tray slot (Figure 53, pos. 3) in order to disconnect the
connector for fan power and control (Figure 32, pos. 3) from the internal fan control socket (Figure 53, pos. 10).
4. Pull the fan tray completely out from the fan tray slot (Figure 53, pos. 3).
5. Replace the defective fan tray with a new one.
6. Insert the functional fan tray (Figure 53, pos. 2) into the fan tray slot (Figure 53, pos. 3).
7. Secure the fan tray by fastening the knurled screws (Figure 52, pos. 2). By fastening of the knurled screws the
proper insertion of the fan tray into the internal socket (Figure 53, pos. 10) is ensured.