600B SERIES MAINTENANCE MANUAL
JULY 2016 - V1.0
PAGE 15
3D. Install the gimbal ring hinge pins (13-562)
on both sides of the gimbal housing and
align the retaining bolt hole with the one in
the gimbal ring.
4D. Place blue
Loctite
243 on the shoulder bolt
(13-406) and install into the gimbal ring
hinge pin on both the port and starboard
sides.
5D. Install the clevis pins (13-315) into the
lower part of the gimbal ring, through the
trim cylinder rod ends and bushings. Secure
the clevis pin by sliding washer (12-352)
over the clevis pin and place cotter pin
(12-352) through the hole at the end of the
clevis pin and bending the ends of the cotter
pin back around the outside of the clevis
pin.
6D. Install the top sensor plate (13-574) by
applying red
Loctite
263 on the two (2)
H.H.C.S. (12-378) and tightening to 35
lb.ft. (47.5 Nm). Align the senor shaft with
the slot on top of the center pivot pin when
placing the plate into position.
Chapter 1 - Sterndrive
(continued)
D.
Sterndrive Installation 660B built prior to 26 January 2016
Chapter 1 - Sterndrive
(continued)
D.
Sterndrive Installation 660B built prior to 26 January 2016
