600B SERIES MAINTENANCE MANUAL
JULY 2016 - V1.0
PAGE 10
5B. Reinstall the top pivot pin cover by applying red
Loctite 263
to the H.H.C.S. (12-378).
Reinstall the bottom pivot pin cover by applying
red
Loctite 263
to the H.H.C.S. (13-310).
Tighten to 35 lb.ft. (47.5 Nm).
NOTE: When reinstalling the top cover with a
rudder indicator, be sure to align the sensor
pin with the slot on top of the drive pivot pin
.
6B. Reattach the steering cylinders to the drive
leg by installing the aft clevis pins (13-341),
washers (12-352), and the cotter pins (13-368)
to the steering cylinder. Repeat the process for
the port and starboard sides.
NOTE: Make sure the steering cylinder bushings
(13-319) are installed on each side of the rod end
prior to installing steering cylinders into the drive
steering tabs.
7B. Remove the lifting ring and install the plug (10-
010) and gasket (10-285). Remove the cap (13-
251) on the oil supply line fitting, and reinstall
the oil supply line (30-997) from the transom
using blue
Loctite
243 on the fitting, and tighten
the fitting.
Secure the continuity cable (30-907) that was
previously removed in step 8A by installing the
self tapping screw (10-479).
8B. Reinstall the cover onto the upper housing.
Install blue
Loctite
243 onto the S.H.C.S. before
placing them through the flat washers and hand
tightening.
Install the two (2) M6 X 14mm S.H.C.S. (12-
951) into the forward upper side of the cover.
Install the two (2) M6 X 25mm S.H.C.S. (11-
897) into each forward bottom side hole in the
cover. Reinstall the aft two (2) M8 X 18mm
S.H.C.S. (13-369) from the back of the upper
housing cover, and reinstall the cover from the
upper housing.
Chapter 1 - Sterndrive
(continued)
B.
Installation 620B/680B all build dates; and 660B built after 26 January 2016
