Kondo KXR-R4LL, Инструкция по сборке

Страница: 42 / 60

42
Adjust the trim position before operating the robot. Trim adjustment refers to correcting
slight deviations in servo origins that were not perceived during assembly.
The trim position is a pose in which only the trim is adjusted with the robot in its basic
position.
The KXR-R4LL standard is the robot with its arms extended. In the Hello̲KXR-R4LL
(Vx.xx) project, the Trim Adjustment tab (explained below) is preset so that KXR-R4LL
assumes the trim position. The next process involves adjusting deviations in each servo
motor from the trim position.
In this process, put the robot in a completely upright position with bilateral symmetry. If
you run a motion with the trim out of alignment, the robot will not function properly or
topple over easily, so make sure to perform the process carefully.
■ Trim Adjustment
Types of Positions
●
Neutral Position:
The state in which all servos are positioned to their Neutral (origin) position. This is used for
confirmation after assembly.
●
Trim Position:
The pose where only the trim is adjusted from the Neutral Position. This becomes the robot's
basic posture. It is the upright standing posture for
KXR-R4LL , and is used when adjusting trim.
● Home Position:
The first and last position when motions are run. When the motion is completed,
the robot returns to the home position, so if it stops partway through, check for
motions that could not be performed, malfunctions or other such trouble.
Trim Adjustment １